Hit enter to search or ESC to close
The windows and doors arrive with built-in head flashings, jamb flashings, cavity closers, end dams, sill support bars and clever water management features.
You no longer need to worry about internal tapes, PEF rods or expanding foams. So there’s less onsite materials, waste and handling, saving you time and money.
All you need to do is place the window in the hole and screw into position through an outer fixing fin.
At the end of the day, you can close in a house much faster, and get onto other jobs sooner.
The windows and doors have built-in head flashings, jamb flashings, cavity closers, end dams, sill support bars and clever water management features.
Internal tapes, PEF rods, expanding foams or silicones are no longer required. So there are less onsite materials, waste and handling, saving time and money.
Simply place the window in the hole and screw into position through an outer fixing fin.
Much has been done to improve the weathertightness with these windows. The window opening weatherline has moved out to the face of the wall underlay. This no longer allows the weatherline to extend inwards to the back side of the internal wall lining, so any failure water would drop into the cavity instead of onto the framing trimmer. The air seal has also moved out to the wall underlay line.
The window is screwed into position through an outer fixing fin then Smartfit™ 60mm flashing tape is applied over the fin and wall underlay to create an air seal.
When used in conjunction with a 'rigid air barrier' early close in and a lock up ready build can be achieved. Pre-line can start up to three weeks earlier than the conventional construction method.
The Smartfit™ Joinery System has been appraised for use as window and door joinery within the following scope:
The product will, if employed in accordance with the supplier's installation and maintenance requirements, assist with meeting the following provisions of the building code:
The product has and can make available the following additional evidence to support the above statements:
Refer to BRANZ Appraisal 868 (2014) section 7.1
Refer to BRANZ Appraisal 868 (2014) section 21.1
Refer to BRANZ Appraisal 868 (2014) section 11.1
Fully open, louvre blades are close to horizontal. This means they provide very little resistance to…
Maximum sizes for Roof windows and sashes vary by width, height, wind zone and glazing requirement. …
Stellar Doors™ offer a premium range of standard & Thermally Broken entrance doors
Bifold doors allow for unrestricted access to the outdoors and maximise the amount of light in a roo…
French doors are a timeless classic that add a sense of openness, structure and beauty to any home.
The Foldback™ Bifold's unique patented system allows the door panels to fold flat against the claddi…
Whether it be a cosy retreat in the winter or a cool haven in the summer, your conservatory can add …
For consistent styling throughout your home...